Customer Question
- Total activity 214
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 82
Comments
Recent activity by Customer Question-
So, I got the job done by making a tool that would hook to the pump bracket and allow me to pull the pump through its arch ( I had to take the alternator off to get better access) . There are indee...
-
Hi FS,It has taken me some time but I have finally managed to get the gearbox on my car sorted.I took it to a local auto gearbox specialist in Darlington (S. Blackett & Son) who went out for a test...
-
Check Strap was fine but the battery wasn't in the best condition, had a higher cranking amp battery fitted and now starts on the button like it should, even the windows close/open quicker lolThank...
-
Thanks For the reply, i've just managed to get her to start (with a jump pack,) so i'll get her on a ramp tomorrow and check the strap,(also check battery as the tires were really old and i've had ...
-
Thank you fo rthe response. I was unable to get the power locking to work with either of the three keys. For the passenger side window, I sprayed WD40 onto the full length of the felt guides, but n...
-
Thank you for the response, Andy.1. How do I access the felt for lubrication?2. How may I operate the power locks without the fob?
-
Thanks. Job done!
-
After cleaning all of the grounds I now have spark and the engine now starts with difficulty . It runs but will not "rev" over 1,300 RPMs. When I was changing the valve cover gasket I had to remove...
-
I have the same problem. The engine cranks but no spark. This occurred after changing the valve cover gaskets. I have revisited the wiring that was disturbed during the valve cover work and can fin...
-
thanks for the reply, figured its just down to using a few gallons till I feel confident that the tank is clean